Ignore the SSL error and log in.1 Cyclades-TS User Guide Version Release 1 This document contains proprietary information of Cyclades and is not to be disclosed or used except in accordance with applicable contracts or agreements. Connect your computer to the Ethernet interface and assign your computer an IP address in the 192.168.161.0/24 subnet.Īssign your a computer an IP in the 192.168.161.0/24 subnet.ĭefault gateway and DNS server settings aren’t necessary. The default IP address of the device is 192.168.161.5. Release the button and the unit will reboot with factory settings applied. Power on the device and use a paper clip to hold down the reset button until the “Ready” light on the front panel goes off. Whenever I get a new-to-me piece of networking gear, I like to do a factory reset so I can be sure that I’m working with a clean slate. I’m leaving this step out of the following sections in the interest of not sounding like a broken record.īe sure to click Save & apply to commit your changes Whenever you make any settings changes in the web interface, be sure to commit them by clicking the S ave & apply button. I recommend downloading the manual and the latest firmware before getting started. You can download manuals and firmware here. Note that usernames, not just passwords, are case-sensitive. You can use log in with either account when performing the steps in this post. The main difference between these accounts is that the root account has full CLI access, while admin only has access to the configuration menu in the CLI. Digi’s 200 page manual does a good job of that! Before You Get Startedīy default, the unit comes pre-configured with 2 accounts, root and admin. These units are pretty feature-rich and this guide isn’t meant to cover every single feature. One thing to watch out for is some of the cheaper ebay listings are for models that use 48VDC power, so be sure that the unit you’re purchasing uses AC power.īelow I have outlined some of the procedures that you will most commonly need/want to go through when provisioning one of these. The only difference feature-wise is the number of ports, and some CM 48s have dual power supplies. They can be had on ebay for less than $150. The CM 32 and CM 48 seem to be the most plentiful and least expensive. Many terminal servers from other manufacturers require rollover cables. These units support SSH, have a nice web management interface, and use standard patch cables for the console port connections. The octal cables also create a cable management nightmare. If you go this route, you’re going to have a hard time spending less than $200 when you factor in the cost of the router along with the requisite octal cables. A popular option is to use an old Cisco 2511. I wanted an affordable terminal server for my Cisco home lab.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
February 2023
Categories |